Honda C8R600F4 Service Manual page 201

CRANKCASE SEPARATION
Refer to Service Information (page 11-1) for remov-
al of necessary parts before disassembling the
crC111kcase.
Remove the bolts and water hose joint.
Remove the oil pressure switch.
Remove the bolts and speed sensor.
CAUTION:
Remove the speed sensor before separating the
crankcase. Do not separate or assemble the crank-
case with the speed sensor installed.
Do not use the
Remove the bolt, washer and ignition pulse genera-
ianition pulse
tor rotor.
generator rotor
Remove the washer bolt and cam chain guide.
tangs to hold it in
Remove the cam chain and timing sprocket.
place while
Remove the pivot bolt, cam chain tensioner and
removing the bolt.
washer.
Remove the three bolts and bearing set plate.
Loosen the seven 6 mm bolts and five 8 mm bolts
in a crisscross pattern in 2 or 3 steps.
Remove the bolts and sealing washers.
CRANKCASE/TRANSMISSION
11-3