Honda C8R600F4 Service Manual page 318

IGNITION SYSTEM
17-6
Connect the peak voltage adaptor or tester probes
to the connector terminals of the wire harness side.
TOOLS:
Peak voltage tester (U.S.A. only) or
Peak voltage adaptor 07HGJ-0020100
with commercially available digital multimeter
(impedance
10
M
S'd
/DCV minimum)
CONNECTION:
Yellow wire terminal (+)-to-White/
yellow wire terminal { - )
Turn the ignition switch
ON
and engine stop switch
to RUN.
Shift the transmission into neutral.
Crank the engine with the starter motor and meas-
ure the ignition coil primary peak voltage.
PEAK VOLTAGE:
0.7 V minimum
If the peak voltage measured at ICM connector is
abnormal, measure the peak voltage at the pulse
generator connector.
Remove the right side fairing (page 2-4).
Disconnect the clutch cable (page 9-3).
Disconnect the ignition pulse generator 2P (red)
connector and connect the peak voltage adaptor or
tester probes to the connector terminals of the
ignition pulse generator side.
In the same manner as at the ICM connector, meas-
ure the peak voltage and compare it to the voltage
measured at the ICM connector.
•If the peak voltage measured at the ICM is
abnormal and the one measured at the ignition
pulse generator is normal, the wire harness has
an open or short circuit, or loose connection.
• If both peak voltages are lower than standard
value, follow the checks described in the trouble-
chooting chart (page 17-3).
Install the removed parts in the reverse order of
removal.