Sidestand Switch; Clutch Switch; Switch Deadlock - Honda 2010 CBX 250 Workshop Manual

LIGHTS/INDICATORS/SWITCHES

CLUTCH SWITCH

Release the connector 2P breaker clutch and verify if there is
a continuity between the terminals of the switch. There must
be continuity when operated lever clutch and there must be
continuity when released the lever clutch.

SWITCH DEADLOCK

Remove the cover of sprocket of transmission (page
6-3). Release the terminal type ring breaker of deadlock.
Place the transmission in neutral and check to see if
there is a continuity between the terminal of the cable
Light green / Red and the earth. There must be
continuity when the transmission is at an impasse and
must not be continuity when the transmission is posi-
tioned in any way.

SIDESTAND SWITCH

INSPECTION
Release the connector 3P breaker of side stand.
Check if there is a continuity between the terminals con-
nector. There must be continuity between the terminals,
according to the c code presented at the table below:
G/W
Lower Support
Support collected O
19-12
G Y/BI
O O
O
CLUTCH SWITCH
WASHER
NUT TERMINAL
BREAKER OF
DEADLOCK
CBX250
TERMINAL
BREAKER OF
DEADLOCK