Honda C8R600F4 Service Manual page 264

REAR WHEEL/SUSPENSION
WHEEL
Check the rim runout by placing the wheel in a
trnino st;rnrL Spin thP whi:>P.I slowly
;:incl
rn::irl thP.
runout using a dial indicator.
Actual runout is 1/2 the total indicator reading.
SERVICE LIMITS: RADIAL: 2.0 mm (0.08 in)
AXIAL:
2.0 mm (0.08 in)
WHEEL BEARING
I urn the inner race ot each bearing with your finger.
The bearings should turn smoothly and quietly.
Also check that the bearing outer race fits tightly in
the hub.
Replace the wheel
Remove and discard the bearings if the races do
bearings in pairs.
not turn smoothly and quietly, or if they fit loosely
in the hub.
14-4
DRIVEN SPROCKET
Check the condition of the driven sprocket teeth.
Replace the sprocket if worn or damaged.
NOTE:
•If the driven sprocket requires replacement,
inspect the drive chain and drive sprocket.
• Never install a new drive chain on a worn
sprocket or a worn chain on new sprockets. Both
chain and sprocket must be in good condition, or
the replacement chain or sprocket will wear
rapidly.
DISASSEMBLY
Remove the right dust seal.
Remove the bolts and brake disc.
OK NO GOOD
0
x
~~