Honda C8R600F4 Service Manual page 277

INSTALLATION
NOTE:
When tightening the lock nut with the lock nut
wrench, refer to torque wrench reading information
on page 14-1 "SERVICE INFORMATION".
CAUTION:
Be sure to tighten all swingarm pivot fasteners to
the specified torque in the specified sequence
described below. If you mistake the tightening
torque or sequence, loosen all pivot fasteners,
then tighten them again to the specified torque in
the specified sequence.
1. Install the left and right adjusting bolts so that
they do not project out of the frame inner surface.
2.
Obtain a spare pivot bolt
(P/N
5210·1-MBW-OOO)
for this model or use a 20 mm (0.8 in) O.D. shaft.
Set the swingarm into the frame and the shock
arm plates and temporarily insert the spare pivot
bolt or 20 mm 0.D. shaft from the left side to
support the swingarm.
Be sure that the swingarm is properly aligned.
3. Tighten the right adjusting bolt.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Loosen the right adjusting bolt and retighten it to
the specified torque.
TORQUE : 7 N·m (0.7 kgf·m, 5. l lbf·ft)
4.
Install the right lock nut.
Hold the right adjusting bolt and tighten the right
lock nut.
TOOL:
Lock nut wrench 07908-4690003 or
07908-'1690002
TORQUE: Actual: 64 N·m (6.5 kgf.m, 47 lbf.ft)
Indicated: 58 N·m (5.9 kgf.m, 43 lbf·ft)
REAR WHEEL/SUSPENSION
14-17