Honda C8R600F4 Service Manual page 291

Install the boot onto the piston and into the master
cylinder.
Apply silicone grease to the brake lever contacting
area of the master piston.
Apply silicone grease to the pivot bolt sliding sur-
face.
Install the brake lever assembly and pivot bolt.
Tighten the pivot bolt.
TORQUE : 1 N·m (0.1 kgf·m , 0.7 lbf·ft)
Install and tighten the pivot nut.
TORQUE : 6 N·m (0.6 kgf.m , 4.3 !bf.ft)
Install the front brake light switch with the screw.
TORQUE ; 1 N·m (0.1 kgf·m , 0.7 lbf·ft)
Install the master cylinder and holder with the
"UP" mark facing up.
Align the end of the master cylinder with the punch
mark on the handlebar, and tighten the upper bolt
first, then tighten the lower bolt.
TORQUE: 12 N·m (1.2 kgf.m, 9 lbf.ft)
Connect the brake hose to the master cylinder with
the oil bolt and new sealing washers and tighten
the oil bolt.
TORQUE : 34 N·m (3.5 kgf.m , 25 I bf.ft)
Connect the front brake light switch connectors.
Fill and bleed the front hydraulic system (page 15-
3).
HYDRAULIC BRAKE
BRAKE LEVER PIVOT NUT
I
15-11