Honda C8R600F4 Service Manual page 295

Install the push rod into the master cylinder.
Install the snap ring into the groove in the master
cylinder, using the special tool.
TOOL:
Snap ring pliers
07914-SA50001
CAUTION:
Be certain the snap ring is firmly seated in the
groove.
Apply silicone grease to the boot groove in the
push rod and install the piston boot into the master
cylinder and the groove in the push rod.
If the push rod joint is reintalled, adjust the push
rod length so that the distance from the center of
the master cylinder lower mounting hole to the cen-
ter of the joint pin hole is 100 mm (3.9 in). After ad-
justment, tighten the joint nut.
TORQUE: 18 N·m (1.8 kgf.m, 13 lbf.ft)
Connect the master cylinder push rod joint to the
brake pedal with the joint pin and a new cotter pin.
Apply grease to the brake pedal pivot.
Install the brake pedal onto the pivot shaft.
Install the wave washer, plain washer and snap
ring onto the pivot shaft.
Install the master cylinder with the mounting bolts
and step guard.
HYDRAULIC BRAKE
15-15