Honda C8R600F4 Service Manual page 267

Drive in the driven flange bearing squarely with the
marking side facing up until it is fully seated.
TOOLS:
Driver 07749-0010000
Attachment, 52 X 55 mm 07746-0010400
Pilot, 20
mm 077 46-0040500
Drive in a new right bearing squarely with the mark-
ing side facing up until it is fully seated.
Install the distance collar_
Drive in a new left bearing squarely with the mark-
ing side facing up until it is fully seated.
TOOLS:
Driver 07749-0010000
Attachment,
42 X 47
mm
07746-0010300
Pilot, 20
mm 077 46-0040500
Install the damper rubbers into the left wheel hub.
Coat a new 0-ring with grease and install it into the
hub groove.
Apply grease to the mating surface of the wheel
hub (side surface) and final driven flange.
Install the driven flange assembly into the left
wheel hub.
When the driven sprocket is replaced, install a new
sprocket and tighten the nuts.
TORQUE :
88 N·m (9.0 kgf·m , 65 I bf.ft)
Apply grease to a new dust seal lip and install it un-
til it is flush with the driven flange.
REAR WHEEL/SUSPENSION
14-7