Honda C8R600F4 Service Manual page 265

Remove the left dust seal.
NOTE:
If
you
will replace the final driven sprocket, loosen
the driven sprocket nuts.
Remove the final driven flange assembly from the
left wheel hub.
Remove the damper rubbers and 0-ring.
Replace the wheel
Install the bearing remover head into the bearing.
bearings in pairs.
From opposite side, install the bearing remover
Do not reuse old
shaft and drive the bearing out of the wheel hub.
bearings.
Remove the distance collar and drive out the other
bearing.
TOOLS:
Bearing remover shaft
Bearing remover head,
20mm
077 46-0050100 or
equivalent commercially
available in U.S.A.
077 46-0050600 or
equivalent commercially
available in U.S.A.
REAR WHEEL/SUSPENSION
14-5