Honda C8R600F4 Service Manual page 216

CRANKSHAFT /PISTON/CYLINDER
Install the stopper pins and gear springs onto the
primary drive gear as shown.
Apply molybdenum oil solution to the sub-gear
sliding surface.
Temporarily install the sub-gear by aligning the
punch mark with the hole in the primary drive gear.
Install the cone spring onto the sub-gear.
Install the sub-gear onto the primary drive gear so
that it evenly touches the primary drive gear by
prying the sub-gear with a 5 mm pin or screwdriver
while the stoppers on the reverse side of the sub-
gear are pushing against the gear springs.
Install with the
Install a new snap ring into the ring
groove
in the
large tab facing
crankshaft securely with the end gap at right angle
the right and the
to the crankshaft cut-outs by aligning the large tab
chamfered side
edge with the sub-gear
groove
as shown.
facina the gear.
12-4
STARTER CLUTCH NEEDLE BEARING
REPLACEMENT
Remove the needle bearing with the bearing puller.
TOOL:
Universal bearing puller
07631-0010000
CAUTION:
To protect the crankshah main journal from the
bearing puller claws, cover the mainshaft journal
properly; worn main journal bearings are usable as
protectors.