Honda C8R600F4 Service Manual page 272

REAR WHEEL/SUSPENSION
Press the needle bearing out of the shock link pivot
using the special tools.
TOOLS'.
Driver attachment handle 07949-3710001
Attachment, 22 X 24 mm
07746-0010800
Pilot, 17 mm 07746-0040400
Apply grease to the needle rollers of a new bearing.
Press in the Carefully press the needle bearing in the link pivot
bearing with the
until the depth from the shock link outer surface is
marking side
5.2-5.7 mm (0.20-0.22 in), using the same tools.
facing up.
14-1?
Apply grease to new dust seal lips and install them
into the shock link pivots until they are seated.
Install the pivot collars.
INSTALLATION
Install the shock link into the link brackets and the
bolt from the left side.
Install tt11:1 11ut.
Install the shock arm plates with the arrow facing
the left and front side and the bolts from the right
side.
Install the nuts.
Tighten the link bracket nuts if they were loosened
(page. 7-8).
Tighten the all suspension linkage nuts.
TORQUE : 44 N·m (4.5 kgf·m , 33 lbf·ft)
5.2-5.7 mm (0.20-0.22 in)
T