Honda C8R600F4 Service Manual page 180

CLUTCH/GEARSHIFT LINKAGE
Raise the fuel tank and support it (page 2-3).
Loosen the cam chain tensioner (page 8-4).
Be careful not to
Align the gear teeth of the scissors gears (primary
bend the ignition
drive gear and sub-gear) by inserting a
5
mm steel
pulse generator
pin or screwdriver at least 61 mm in length into the
rotor tangs.
gear hole through the hole in the crankcase, and
remove the clutch outer.
Tho ignition puloc gonorator rotor muot bo aligned
as shown.
IGNITION PULSE
GENERATOR ROTOR
Remove the oil pump driven sprocket bolt and
washer.
Remove the oil pump driven sprocket, drive chain
and drive sprocket as a set.
Remove the clutch outer guide.
INSPECTION
LIFTER BEARING
Turn the inner race of the lifter bearing willr yuur
finger.
The bearing should turn smoothly and quietly.
Also check that the outer race of the bearing fits
tightly in the pressure plate.
Replace the bearing if the inner race does not turn
smoothly, quietly, or if the outer race fit loosely in
the pressure plate.
Drive the bearing out of the pressure plate.
Drive a new bearing into the plate with its mark
side facing out.
TOOLS:
Driver 07749-0010000
Attachment, 32 X 35 mm 07746-0010100
Pilot, 17 mm 07746-0040400
CLUTCH SPRING
Replace the clutch
Measure the clutch spring free length.
springs as a set.
SERVICE LIMIT: 45.2 mm (1.78 in)
Q .. fi