Honda C8R600F4 Service Manual page 246

FRONT WHEEL/SUSPENSION/STEERING
1~-1~
Hold the fork slider in a vise with a soft jaws or
shop towel.
Install the socket bolt with a new sealing washer
;:rnrl tiohtP.n it.
TORQUE : 34 N·m {3.5 kgf.m , 25 lbf·ft)
NOTE:
If the fork damper turns together with the socket
bolt, temporarily install the fork spring, spring seat,
joint collar and fork cap.
Place the guide bushing over the fork tube and rest
it on the slider. Put the back-up ring and an old
bushing or equivalent tool on top of the guide
bushing.
Drive the bushing into place and remove the old
bu!<:hino or P.q11iv::ilent tool.
Wrap vinyl tape around the fork tube top end to
avoid damaging the oil seal lip.
Coat a new oil seal with fork fluid and install it over
the fork tube with the marked side facing up.
Drive the oil seal until the stopper ring groove is
visible.
TOOLS:
Fork seal driver weight
079~7-KA60100
Fork seal driver attachment,
43 mm I. 0. 07947-KA40200
Install the stopper ring into the groove in the fork
slider.
~~
SEALING WASHER
-=-
DUST SEAL,
STOPPER RING
.~ ~
OIL SEAL _
__,...,,r.ri
...............
BACK-UP RING
GUIDE BUSHING
DRIVER WEIGHT