Commands For Arp Configuration - Edge-Core ES4624-SFP Basic Management Manual

3. Clear dynamic ARP
Command
clear arp-cache
4. Clear the statistic information of ARP message
Command
Admin mode
clear arp traffic

13.5.3 Commands for ARP Configuration

13.5.3.1 arp
Command: arp <ip_address> <mac_address> {interface [ethernet] <portName>}
no arp <ip_address>
Function: Configures a static ARP entry; the "no arp <ip_address>" command deletes a
ARP entry of the specified IP address.
Parameters: <ip_address> is the IP address, at the same filed with interface address;
<mac_address> is the MAC address; ethernet stands for Ethernet port; <portName>
for the name of layer2 port.
Default: No static ARP entry is set by default.
Command mode: Port mode
Usage Guide: Static ARP entries can be configured in the switch.
Example: Configuring static ARP for interface VLAN1.
Switch(Config-if-Vlan1)#arp 1.1.1.1 00-03-0f-f0-12-34 eth 1/2
13.5.3.2 clear arp-cache
Command: clear arp-cache
Function: Clears arp table.
Parameters: N/A.
Command mode: Admin Mode
command disables the proxy ARP.
Explanation
The command "clear arp-cache" clears
the content of current ARP table, but it
does not clear the current static ARP table
Explanation
Clear the statistic information of ARP
messages of the switch.
400