Edge-Core ES4624-SFP Basic Management Manual page 27

telnet-server enable in the global mode as below:
Switch>enable
Switch#config
Switch(config)# telnet-server enable
Step 2: Run Telnet Client program.
Run Telnet client program included in Windows with the specified Telnet target.
Fig 1-7 Run telnet client program included in Windows
When accessing a switch with IPv6 address, it is recommended to use the Firefox
browser with 1.5 or later version. For example, if the IPv6 address of the switch is
"3ffe:506:1:2::3", enter the switch address at the address bar: http://[3ffe:506:1:2::3],
where the address should be in the square brackets.
Step 3: Login to the switch
Login to the Telnet configuration interface. Valid login name and password are
required, otherwise the switch will reject Telnet access. This is a method to protect the
switch from unauthorized access. As a result, when Telnet is enabled for configuring and
managing the switch, username and password for authorized Telnet users must be
configured with the following command:
username <username> privilege <privilege> [ password (0|7) <password>]
To open the local authentication style with the following command: authentication
line vty login local. Privilege option must exist and just is 15. Assume an authorized user
in the switch has a username of "test", and password of "test", the configuration
procedure should like the following:
Switch>enable
Switch#config
Switch(config)#username test privilege 15 password 0 test
Switch(config)#authentication line vty login local
Enter valid login name and password in the Telnet configuration interface, Telnet
user will be able to enter the switch's CLI configuration interface. The commands used in
the Telnet CLI interface after login is the same as that in the Console interface.
27