Edge-Core ES4624-SFP Basic Management Manual page 310

10.6.1.3 Commands for Mac Address Binding configuration
10.6.1.3.1 clear port-security dynamic
Command: clear
<interface-id> ]
Function: Clear the Dynamic MAC addresses of the specified port.
Command mode: Admin Mode.
Parameter: <mac-addr> stands MAC address; <interface-id> for specified port number.
Usage Guide: The secure port must be locked before dynamic MAC clearing operation
can be perform in specified port. If no ports and MAC are specified, then all dynamic
MAC in all locked secure ports will be cleared; if only port but no MAC address is
specified, then all MAC addresses in the specified port will be cleared.
Example: Delete all dynamic MAC in port1.
Switch#clear port-security dynamic interface Ethernet 1/1
10.6.1.3.2 mac-address-table periodic-monitor-time
Command: mac-address-table periodic-monitor-time <5-86400>
Function: Set the MAC monitor interval to count the added and deleted MAC in time,
and send out them with trap message.
Parameter: <5-86400>: the interval is 5 to 86400 seconds.
Command mode: Global Mode.
Default: 60 seconds.
Usage Guide:
Example: Set the MAC monitor interval as 120 seconds.
Switch(Config)#mac-address-table periodic-monitor-time 120
10.6.1.3.3 port-security
Command: port-security
no port-security
Function: Enable MAC address binding function for the port, the "no port-security"
command disables the MAC address binding function for the port.
Command mode: Port mode
Default: MAC address binding is not enabled by default.
Usage Guide: The MAC address binding function, Spanning Tree and Port Aggregation
functions are mutually exclusive. Therefore, if MAC binding function for a port is to be
enabled, the Spanning Tree and Port Aggregation functions must be disabled, and the
port enabling MAC address binding must not be a Trunk port.
Example: Enable MAC address binding function for port 1.
port-security dynamic [address <mac-addr>
310
| interface