Edge-Core ES4624-SFP Basic Management Manual page 82

Usage Guide: When the old information in the log buffer zone is no longer concerned,
we can use this command to clear all the information
example：Clear all information in the log buffer zone sdram
Switch# clear logging sdram
2.2.9.2.2.5 logging host
Command: logging {<ipv4-addr> | <ipv6-addr>} [ facility <local-number> ] [level
<severity>]
no logging {<ipv4-addr> | <ipv6-addr>}[ facility <local-number> ]
Function: The command is used to configure the output channel of the log host. The
"no" form of this command will disable the output at the log host output channel
Parameter: <ipv4-addr> is the IPv4 address of the host, <ipv6-addr> is the IPv6
address of the host; <local-number> is the recording equipment of the host with a valid
range of local0～local7,which is in accordance with the facility defined in the RFC3164;
<severity> is the severity threshold of the log information severity level,The rule of the
log information output is explained as follows：only those with a level equal to or higher
than the threshold will be outputted. For detailed description on the severity please refer
to the operation manual.
Command Mode: Global Mode
Default: No log information output to the log host by default. The default recorder of the
log host is the local0, the default severity level is warnings
Usage Guide: Only when the log host is configured by the logging command, this
command will be available. We can configure many IPv4 and IPv6 log hosts.
Example 1： Send the log information with a severity level equal to or higher than warning
to the log server with an IPv4 address of 100.100.100.5, and save to the log recording
equipment local1
Switch(config)# logging 100.100.100.5 facility local1 level warnings
Example 2：Send the log information with a severity level equal to or higher than
informational to the log server with an IPv6 address of 3ffe:506:1:2::3, and save to the log
recording equipment local1
Switch(config)# logging 3ffe:506:1:2::3 facility local1 level informational
2.2.9.2.2.6 logging executed-commands
Command: logging executed-commands {enable | disable}
Function: Enable or disable the logging executed-commands.
Parameter: None.
Command Mode: Global mode.
82