Edge-Core ES4624-SFP Basic Management Manual page 361

Command Mode：VLAN interface configuration mode
Default：The system default is no IP address configuration.
Usage Guide：This command configures IP address on VLAN interface manually. If
optional parameter secondary is not configured, then it is configured as the primary IP
address of VLAN interface; if optional parameter secondary is configured, then that
means the IP address is the secondary IP address of VLAN. One VLAN interface can
only have one primary IP address and more than one secondary IP addresses. Primary
IP and Secondary IP all can be used on SNMP/Web/Telnet management. Furthermore,
the switch also provides BOOTP/DHCP manner to get IP address.
Example： The IP address of switch VLAN1 interface is set to 192.168.1.10/24.
Switch(Config-if-Vlan1)#ip address 192.168.1.10 255.255.255.0
13.2.2.3 IPv6 Configuration
The configuration Task List of IPv6 is as follows:
1. IPv6 basic configuration
Configure interface IPv6 address
（1）
Configure IPv6 static routing
（2）
2. IPv6 Neighbor Discovery Configuration
Configure DAD neighbor solicitation message number
（1）
Configure send neighbor solicitation message interval
（2）
Enable and disable router advertisement
（3）
Configure router lifespan
（4）
（5） Configure router advertisement minimum interval
Configure router advertisement maximum interval
（6）
Configure prefix advertisement parameters
（7）
Configure static IPv6 neighbor entries
（8）
Delete all entries in IPv6 neighbor table
（9）
（10） Set the hoplimit of sending router advertisement
（11） Set the mtu of sending router advertisement
（12） Set the reachable-time of sending router advertisement
（13） Set the retrans-timer of sending router advertisement
（14） Set the flag representing whether information other than the address
information will be obtained via DHCPv6
（15） set the flag representing whether the address information will be obtained via
DHCPv6
3. IPv6 Tunnel configuration
Create/Delete Tunnel
（1）
Configure Tunnel Source
（2）
361