Edge-Core ES4624-SFP Basic Management Manual page 47

Hide thumbs Also See for ES4624-SFP:

Table of Contents

leave the terminal for a long time.

Example: Set the Admin user password to "admin".

Switch(config)#enable password 0 admin

2.1.1.17 end

Command: end

Function: Quit current mode and return to Admin mode when not at User Mode/ Admin

Command mode: Except User Mode/ Admin Mode

Example: Quit VLAN mode and return to Admin mode.

Switch(config-vlan1)#end

2.1.1.18 exec-timeout

Command: exec-timeout <minutes > [<seconds>]

no exec-timeout

Function:Configure the timeout of exiting admin mode. The "no exec-timeout"

command restores the default value.

Parameters: < minute > is the time value shown in minute and ranges between

0~35791.<seconds> is the time value shown in seconds and ranges between 0~59.

Command mode:Global mode

Default:Default timeout is 10 minutes.

Usage guide: To secure the switch, as well to prevent malicious actions from

unauthorized user, the time will be count from the last configuration the admin had made,

and the system will exit the admin mode at due time. It is required to enter admin code

and password to enter the admin mode again. The timeout timer will be disabled when

the timeout is set to 0.

Example: Set the admin mode timeout value to 6 minutes

Switch(config)#exec-timeout 6

2.1.1.19 exit

Command: exit

Function: Quit current mode and return to it's previous mode.

Command mode: All Modes

Usage Guide: This command is to quit current mode and return to it's previous mode.

Example: Quit global mode to it's previous mode

Switch(config)#exit

Troubleshooting