Edge-Core ES4624-SFP Basic Management Manual page 366

tunnel destination {ipv4-address>
| <ipv6-address>}
no tunnel destination
（4）Configure Tunnel Next-Hop
Command
Tunnel Configuration Mode
tunnel nexthop <ipv4-daddress>
no tunnel nexthop
（5）Configure Tunnel Mode
Command
Tunnel Configuration Mode
tunnel mode [[gre] | ipv6ip [ 6to4 |
isatap]]
no tunnel mode
（6）Configure Tunnel Routing
Command
Global mode
[no] ipv6
<ipv6-address/prefix-length>
{<interface-type
interface-number>
<tnl-id>}
13.2.2.3.1 Commands for IPv6 configuration
13.2.2.3.1.1 description
Command: description <desc>
no description
Function: Configure the tunnel description. The no operation of this command will delete
the tunnel description.
Parameters: <desc> is the tunnel description, its length can not exceed 256 characters.
Command Mode: Tunnel Configuration Mode.
Default: There is no tunnel description by default.
Configure tunnel destination end IPv4/IPv6
address. The NO command deletes the IPv4
address of tunnel destination end.
Description
Configure tunnel next-hop IPv4 address. The
NO command deletes the IPv4 address of
tunnel next-hop end.
Explanation
Configure tunnel mode. The NO command
clears tunnel mode.
Explanation
route
Configure tunnel routing. The NO command
clears tunnel routing.
| tunnel
366