Commands For Urpf - Edge-Core ES4624-SFP Basic Management Manual

ip urpf enable
{allow-default-route }
no ip urpf enable
3. Display and debug URPF relevant information
Command
Admin mode
debug l4driver urpf {notice |warn
|error}
no debug l4driver urpf {notice | warn |
error}
Admin and Config Mode
show urpf
show urpf rule ipv4 num interface
{ethernet IFNAME |IFNAME}
show urpf rule ipv6 num interface
{ethernet IFNAME |IFNAME}
show urpf rule ipv4 interface {ethernet
IFNAME |IFNAME}
show urpf rule ipv6 interface {ethernet
IFNAME |IFNAME}

13.4.3 Commands for URPF

13.4.3.1 urpf enable
Command: urpf enable
no urpf enable
Function：Enable the global URPF function.
Command mode: Global Mode
Default：The URPF protocol module is disabled by default.
Example:
Switch(config)#urpf enable
13.4.3.2 ip urpf enable
Command：ip urpf enable {loose | strict} {allow-default-route |}
no ip urpf enable
{loose | strict}
Enable and disable URPF on port.
Explanation
Enable the URPF debug function to
display error information if failures occur
during the installation of URPF rules.
Display which interfaces have been
enabled with URPF function.
Display the number of IPv4 rules bonded
to the port.
Display the number of IPv6 rules bonded
to the port.
Display the details of IPv4 rules bonded
to the port.
Display the details of IPv6 rules bonded
to the port.
395