Edge-Core ES4624-SFP Basic Management Manual page 386

Default： None
Command Mode：Admin Mode
Example：
Switch#debug ipv6 nd
IPv6 ND: rcvd, type <136>, src <fe80::203:fff:fe01:2786>, dst <fe80::203:fff:fe01:59ba>
Displayed information
IPv6 ND: rcvd
type <136>
Src <fe80::203:fff:fe01:2786>
Dst <fe80::203:fff:fe01:59ba>
13.2.4.1.7 debug ipv6 tunnel packet
Command：[no] debug ipv6 tunnel packet
Function： tunnel data packets receive/send debug message.
Parameter： None
Default：None
Command Mode：Admin Mode
Example：
Switch#debug ipv6 tunnel packet
IPv6 tunnel: rcvd,
<fe80::203:fff:fe01:59ba>
IPv6 tunnel packet : rcvd src 178.1.1.1 dst 179.2.2.2 size 128 from tunnel1
Displayed information
IPv6 tunnel packet : rcvd
type <136>
Src 178.1.1.1 dst
Dst 179.2.2.2
13.2.4.1.8 show ipv6 interface
Command：show ipv6 interface {brief|<interface-name>}
Function：Show interface IPv6 parameters.
Parameter：Parameter brief is the brief summarization of IPv6 status and configuration,
and parameter interface-name is Layer 3 interface name.
Default：None
Command Mode：Admin and Configuration Mode
Usage Guide：If only brief is specified, then information of all L3 is displayed, and you
can also specify a specific Layer 3 interface.
Example：
Explanation
Receive ND data report
ND Type
Source IPv6 address
Destination IPv6 address
type <136>, src
Explanation
Receive tunnel data report
ND type
Tunnel source IPv4 address
Tunnel destination IPv4 address
386
<fe80::203:fff:fe01:2786>, dst