Edge-Core ES4624-SFP Basic Management Manual page 374

Usage Guide： IPv6 address and multicast address for specific purpose and local address
can not be set as neighbor.
Example：Set static neighbor 2001:1:2::4 on port E1/1, and the hardware MAC address
is 00-03-0f-89-44-bc
Switch(Config-if-Vlan1)#ipv6 neighbor 2001:1:2::4 00-03-0f-89-44-bc interface Ethernet
1/1
13.2.2.3.1.19 interface tunnel
Command：[no] interface tunnel <tnl-id>
Function：Create/Delete tunnel.
Parameter：Parameter <tnl-id> is tunnel No.
Command Mode：Interface Configuration Mode
Default ：None
Usage Guide：This command creates a virtual tunnel interface. Since there is not
information such as specific tunnel mode and tunnel source, show ipv6 tunnel does not
show the tunnel, enter tunnel mode after creating, under that model information such as
tunnel source and destination can be specified. NO command is to delete a tunnel.
Example：Create tunnel 1
Switch {Config}#interface tunnel 1
13.2.2.3.1.20 ping6
Command：ping6 <ipv6-address>
Function：Validate the reachability of the network.
Parameter：Parameter ipv6-address is destination IPv6 address.
Default：None
Command Mode： Admin Mode
Usage Guide：ping6 being followed by IPv6 address is the default situation, ping6
function can make settings for parameters of ping packets based on user choice. When
ipv6-address is link-local address, it is required to specify port number.
Example：
Switch#ping6
Target IPv6 address:fe80:0000:0000:0000:0203:0fff:fe01:2786
Repeat count [5]: 1
Datagram size in byte [56]: 80
Timeout in milli-seconds [2000]: 2500
Extended commands [n]: Type ^c to abort. n
Sending 1 80-byte ICMP Echoes to fe80:0000:0000:0000:0203:0fff:fe01:2786, timeout is
2 seconds.
374