disables the shown information.
Parameter: <name> is the name of the port.
Default: Do not display.
Command mode: Admin mode.
Usage Guide: None.
Example: Show the information that send the flush packets for the port1/1.
Switch# debug ulpp flush send interface e1/1
Flush packet send on port Ethernet 1/1.
31.3.7 description
Command: description <string>
no description
Function: Configure the description character string of ULPP group. The no command
deletes the description.
Parameter: <string> is the name of ULPP group, the max number of the characters is
128.
Default: Do not configure ULPP name by default.
Command mode: ULPP group configuration mode.
Usage Guide: None.
Example: Configure the description of ULPP group as switch.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)# description switch
31.3.8 flush disable arp
Command: flush disable arp
Function: Disable sending the flush packets of deleting ARP.
Parameter: None.
Default: By default, enable the sending function of the flush packets which are deleted by
ARP.
Command mode: ULPP group configuration mode.
Usage Guide: If configure this command, when the link is switched, it will not actively
send the flush packets to notify the upstream device to delete the entries of ARP.
Example: Disable sending the flush packets of deleting ARP.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)# flush disable arp
637