Edge-Core ES4624-SFP Basic Management Manual page 376

destination.
Example：Configure tunnel destination 203.78.120.5
Switch {Config-if-Tunnel1}#tunnel destination 203.78.120.5
13.2.2.3.1.23 tunnel nexthop
Command：tunnel nexthop <ipaddress>
no tunnel nexthop
Function：Configure tunnel nexthop.
Parameter：<ipv4-daddress> is the ipv4 address of tunnel nexthop.
Command Mode：Tunnel Configuration Mode
Default Situation：None
Usage Guide：This command is for ISATAP tunnel, other tunnels won't check the
configuration of nexhop.
Example：Configure tunnel next hop 178.99.156.8
Switch {Config-if-Tunnel1}#tunnel nexthop 178.99.156.8
13.2.2.3.1.24 tunnel mode
Command：tunnel mode [[gre] | ipv6ip [6to4 | isatap]]
no tunnel mode
Function：Configure Tunnel Mode
Parameter：gre is GRE tunnel.
Command Mode：Tunnel Configuration Mode
Default：None
Usage Guide：In configuring tunnel mode, only specifying ipv6ip indicates configuring
tunnel. Ipv6ip 6to4 indicates it is 6to4 tunnel, ipv6ip isatap indicates it is ISATAP tunnel.
Example：Configure tunnel mode
1、Switch {Config-if-Tunnel1}#tunnel mode ipv6ip
2、Switch {Config-if-Tunnel1}#tunnel mode ipv6ip 6to4
3、Switch {Config-if-Tunnel1}#tunnel mode ipv6ip isatap
13.2.2.3.1.25 clear ipv6 neighbor
Command：clear ipv6 neighbors
Function：Clear the neighbor cache of IPv6.
Parameter：None
Command Mode：Admin Mode
Default：None
Usage Guide：This command can not clear static neighbor.
Example：Clear neighbor list.
376