Cluster Reset Member - Edge-Core ES4624-SFP Basic Management Manual

dst-filename：the specified filename for saving the file in the switch flash;
ascii means that the file transmission follows ASCII standard; binary means that the file
transmission follows binary standard, which is de default mode.
when src-url
ftp://<username>:<password>@<ipadress>/<filename>，in which <username> is the
FTP username <password> is the FTP password <ipadress> is the IP address of the
FTP server,<filename> is the name of the file to be downloaded via FTP.
when src-url is a TFTP address, its form will be: tftp://<ipadress>/<filename>，in which
<ipadress>is the IP address of the TFTP server <filename> is the name of the file to be
downloaded via.
Special keywords used in filename：
Keywords
startup-config
nos.img
Command mode: Admin Mode
Usage Guide： The commander distributes the remote upgrade command to members via
the TCP connections between them, causing the number to implement the remote
upgrade and reboot. Trying to execute this command on a non-commander switch will
return errors. If users want to upgrade more than one member, these switches should be
the same type to avoid boot failure induced by mismatched IMG files.
Example: Remotely upgrade a member switch from the commander switch, with the
member-id being 1 ， src-ul being ftp:// admin:admin @192.168.1.1/nos.img, and dst-url
being nos.img
Switch#cluster update member 1 ftp:// admin:admin @192.168.1.1/nos.img nos.img

30.3.12 cluster reset member

Command: cluster reset member [id<member-id>|mac-address<mac-addr>]
Function: In the commander switch, this command can be used to reset the member
switch.
Parameter: member-id：ranging from 1 to 128. Use hyphen "-" or semicolon ";" to specify
more than one member; if no value is provided, it means to reboot all member switches.
Default：Boot all member switches.
Command mode: Admin Mode
Instructions: In the commander switch, users can use this command to reset a member
switch. If this command is executed in a non-commander switch, an error will be
displayed.
Example: In the commander switch, reset the member switch 1.
is a FTP
source or destination address
start the configuration file
system file
622
address, its form will be: