Ip Forwarding; Introduction To Ip Forwarding; Ip Route Aggregation Configuration Task; Commands For Ip Route Aggregation - Edge-Core ES4624-SFP Basic Management Manual

Mode
Source
Destination
Nexthop

13.3 IP Forwarding

13.3.1 Introduction to IP Forwarding

Gateway devices can forward IP packets from one subnet to another; such
forwarding uses routes to find a path. IP forwarding of ES4624-SFP/ES4626-SFP switch
is done with the participation of hardware, and can achieve wire speed forwarding . In
addition, flexible management is provided to adjust and monitor forwarding.
ES4624-SFP/ES4626-SFP switch supports aggregation algorithm enabling/disabling
optimization to adjust generation of network route entry in the switch chip and view
statistics for IP forwarding and hardware forwarding chip status.

13.3.2 IP Route Aggregation Configuration Task

1. Set whether IP route aggregation algorithm with/without optimization should be
used
Command
ip fib optimize
no ip fib optimize

13.3.3 Commands for IP Route Aggregation

13.3.3.1 ip fib optimize
Command: ip fib optimize
no ip fib optimize
Function: Enables the switch to use optimized IP route aggregation algorithm; the "no ip
fib optimize" disables the optimized IP route aggregation algorithm.
Tunnel type
Tunnel source ipv4 address
Tunnel destination ipv4 address
Tunnel next hop (only applies to ISATAP tunnel)
Explanation
Enables the switch to use optimized IP
route aggregation algorithm; the "no ip fib
optimize" disables the optimized IP route
aggregation algorithm.
392