Vlan Configuration Task List - Edge-Core ES4624-SFP Basic Management Manual

convenience:
Improving network performance
Saving network resources
Simplifying network management
Lowering network cost
Enhancing network security
ES4624&26-SFP Switch Ethernet Ports can works in three kinds of modes: Access,
Hybrid and Trunk, each mode has a different processing method in forwarding the
packets with tagged or untagged.
The ports of Access type only belongs to one VLAN, usually they are used to
connect the ports of the computer.
The ports of Trunk type allow multi-VLANs to pass, can receive and send the
packets of multi-VLANs. Usually they are used to connect between the switches.
The ports of Hybrid type allow multi-VLANs to pass, can receive and send the
packets of multi-VLANs. They can be used to connect between the switches, or to a
computer of the user.
Hybrid ports and Trunk ports receive the data with the same process method, but
send the data with different method: Hybrid ports can send the packets of multi-VLANs
without the VLAN tag, while Trunk ports send the packets of multi-VLANs with the VLAN
tag except the port native VLAN.
The switch implements VLAN and GVRP (GARP VLAN Registration Protocol) which
are defined by 802.1Q. The chapter will explain the use and the configuration of VLAN
and GVRP in detail.

9.1.2 VLAN Configuration Task List

1. Creating or deleting VLAN
2. Assigning Switch ports for VLAN
3. Set The Switch Port Type
4. Set Trunk port
5. Set Access port
6. Set Hybrid port
7. Enable/Disable VLAN ingress rules on ports
8. Configure Private VLAN
9. Set Private VLAN association
10. Specify internal VLAN ID
1. Creating or deleting VLAN
254