Edge-Core ES4624-SFP Basic Management Manual page 174

flow control
no flow control
loopback
no loopback
rate-suppression {dlf | broadcast |
multicast} <packets>
port-scan-mode {interrupt | poll}
no port-scan-mode
rate-violation
[recovery <0-86400>|]
no rate-violation
Global Mode
port-rate-statistics interval [<interval
-value>]
3.2.1.2 Commands for Network Port Configuration
3.2.1.2.1 combo-forced-mode
Command:combo-forced-mode {copper-forced | copper-preferred-auto | sfp-forced
| sfp-preferred-auto }
no combo-forced-mode
Function: Sets to combo port mode (combo ports only); the "no combo-forced-mode"
command restores to default combo mode for combo ports, i.e., fiber ports first.
Parameters: copper-forced forces use of copper cable port; copper-preferred-auto for
copper cable port first; sfp-forced forces use of fiber cable port; sfp-preferred-auto for
fiber cable port first.
Command mode: Port mode
Default: The default setting for combo mode of combo ports is fiber cable port first.
Enables/Disables traffic control function for
specified ports
Enables/Disables loopback test function
for specified ports
Enables the storm control function for
broadcasts, multicasts and unicasts with
unknown
broadcast),
broadcast packet number; the "no" format
of this command disables the broadcast
storm control function.
Configure the scan mode of the port as
"interrupt" or "poll", the no command
restores the default scan mode.
Set the max packet reception rate of a
port. If the rate of the received packet
violates the packet reception rate, shut
<200-2000000>
down this port and configure the recovery
time, the default is 300s. The no command
will disable the rate-violation function of a
port.
Configure
port-rate-statistics.
174
destinations (short
and sets the
the interval
for
allowed
of