Show Port-Group - Edge-Core ES4624-SFP Basic Management Manual

Command: port-group <port-group-number> mode {active|passive|on}
no port-group
Function: Add a physical port to port channel,the no operation removes specified port
from the port channel.
Parameters: <port-group-number> is the group number of port channel, from 1 to 128;
active enables LACP on the port and sets it in Active mode; passive enables LACP on
the port and sets it in Passive mode; on forces the port to join a port channel without
enabling LACP.
Command mode: Port mode
Default: Switch ports do not belong to a port channel by default; LACP not enabled by
default.
Usage Guide: If the specified port group does not exist, then print a error message. All
ports in a port group must be added in the same mode, i.e., all ports use the mode used
by the first port added. Adding a port in "on" mode is a "forced" action, which means the
local end switch port aggregation does not rely on the information of the other end, port
aggregation will succeed as long as all ports have consistent VLAN information. Adding a
port in "active" or "passive" mode enables LACP. Ports of at least one end must be added
in "active" mode, if ports of both ends are added in "passive" mode, the ports will never
aggregate.
Example: Under the Port Mode of Ethernet1/1, add current port to "port-group 1" in
"active" mode.
Switch(Config-If-Ethern et1/1)#port-group 1 mode active

8.4.9 show port-group

Command: show port-group [<port-group-number>] {brief | detail |}
Function: Display the specified group number or the configuration information of all
port-channel which have been configured.
Parameters: <port-group-number> is the group number of port channel to be displayed,
from 1 to 128; "brief" displays summary information; "detail" displays detailed
information.
Command mode: All Configuration Mode
Default: None.
Usage Guide: If the user does not input port-group-number, that means the information
of all the existent port-group are showed; if the port channel corresponds to
port-group-number parameter and is not exist, then print a error message, otherwise
display the current port-channel information of the specified group number.
Example:
246