Edge-Core ES4624-SFP Basic Management Manual page 357

exceed 256 characters.
Default: Do not configure.
Command Mode: VLAN interface mode
Usage Guide: The description information of VLAN interface behind description and
shown under the configured VLAN.
Example: Configure the description information of VLAN interface as test vlan.
Switch(config)#interface vlan 2
Switch(config-if-vlan2)#description test vlan
13.1.3.2 interface vlan
Command:interface vlan <vlan-id>
no interface vlan <vlan-id>
Function: Create a VLAN interface (a Layer 3 interface); the "no interface vlan
<vlan-id>" command deletes the Layer 3 interface specified.
Parameters: <vlan-id> is the VLAN ID of the established VLAN.
Default: No Layer 3 interface is configured upon switch shipment.
Command mode: Global Mode
Usage Guide: When creating a VLAN interface (Layer 3 interface), VLANs should be
configured first, for details, see the VLAN chapters. When VLAN interface (Layer 3
interface) is created with this command, the VLAN interface (Layer 3 interface)
configuration mode will be entered. After the creation of the VLAN interface (Layer 3
interface), interface vlan command can still be used to enter Layer 3 port mode.
Example: Creating a VLAN interface (layer 3 interface).
Switch (config)#interface vlan 1
13.1.3.3 bandwidth
Command: bandwidth <bandwidth>
no bandwidth
Function: Config the bandwidth for Layer 3 Interface. the "no bandwidth" command
recovery the default value. The bandwidth of interface vlan is used to protocol account
but not control the bandwidth of port. For instance, it is use the interface bandwidth
（cost=10^8/bandwidth）when OSPF account the link cost, so change the bandwidth can
result in OSPF link cost changed.
Parameters: <bandwidth> is the bandwidth for interface vlan. Range from 1bits to
10000000000 bits. It is can use unit "k, m, g". There are no decimal numbers after
conversion.
Command mode: Port mode
Default: The default bandwidth for interface vlan is 100,000,000bit.
357