Debug Vrrp; Disable; Enable - Edge-Core ES4624-SFP Basic Management Manual

When this command is used, if the status of an interface monitored turns from up to
down, then the priority of that very router (or L3 Ethernet switch) in its Standby cluster
will decrease, lest Backup cannot changes its status due to lower priority than the Master
when the Master fails.
Example: Configuring vrrp monitor interface to vlan 2 and decreasing amount of priority
to 10.
Switch(Config-Router-Vrrp)# circuit-failover vlan 2 10

27.3.3 debug vrrp

Commands: debug vrrp [ all | event | packet [recv| send] ]
no debug vrrp [ all | event | packet [recv| send] ]
Function: Displays information for VRRP standby cluster status and packet transmission;
the "no debug vrrp" command disables the debug information.
Default: Debugging information is disabled by default.
Command mode: Admin Mode
Example:
Switch#debug vrrp
VRRP SEND[Hello]: Advertisement sent for vrid=[10], virtual-ip=[10.1.10.1]
VRRP SEND[Hello]: Advertisement sent for vrid=[10], virtual-ip=[10.1.10.1]
VRRP SEND[Hello]: Advertisement sent for vrid=[10], virtual-ip=[10.1.10.1]
VRRP SEND[Hello]: Advertisement sent for vrid=[10], virtual-ip=[10.1.10.1]

27.3.4 disable

Commands: disable
Function: Deactivates VRRP
Parameters: N/A.
Default: Not configured by default.
Command mode: VRRP protocol configuration mode
Usage Guide: Deactivates a Virtual Router. VRRP configuration can only be modified
when VRRP is deactivated.
Example: Deactivating a Virtual Router numbered as 10
Switch(config)# router vrrp 10
Switch (Config-Router-Vrrp)# disable

27.3.5 enable

577