Table 196: Address Resolution Protocol Commands; Arp Configuration - Edge-Core ES3528MV2 Management Manual

| IP Interface Commands
C 45
HAPTER
IPv4 Interface
ARP C
ONFIGURATION
C U
OMMAND SAGE
◆ Use the ping command to see if another site on the network can be
reached.
The following are some results of the ping command:
◆
Normal response - The normal response occurs in one to ten
■
seconds, depending on network traffic.
Destination does not respond - If the host does not respond, a
■
"timeout" appears in ten seconds.
Destination unreachable - The gateway for this destination indicates
■
that the destination is unreachable.
Network or host unreachable - The gateway found no corresponding
■
entry in the route table.
When pinging a host name, be sure the DNS server has been defined
◆
(see page 1377) and host name-to-address translation enabled (see
page 1374). If necessary, local devices can also be specified in the DNS
static host table (see
E
XAMPLE
Console#ping 10.1.0.9
Type ESC to abort.
PING to 10.1.0.9, by 5 32-byte payload ICMP packets, timeout is 5 seconds
response time: 10 ms
response time: 10 ms
response time: 10 ms
response time: 10 ms
response time: 0 ms
Ping statistics for 10.1.0.9:
5 packets transmitted, 5 packets received (100%), 0 packets lost (0%)
Approximate round trip times:
Minimum = 0 ms, Maximum = 10 ms, Average = 8 ms
Console#
R C
ELATED OMMANDS
interface (976)
This section describes commands used to configure the Address Resolution
Protocol (ARP) on the switch.

Table 196: Address Resolution Protocol Commands

Command Function
arp timeout Sets the time a dynamic entry remains in the ARP
cache
clear arp-cache Deletes all dynamic entries from the ARP cache
show arp Displays entries in the ARP cache
– 1402 –
page 1376).
Mode
GC
PE
NE, PE