Edge-Core ES4624-SFP Basic Management Manual page 57

Example: Configure treads in each display to 20
Switch#terminal length 20
2.1.1.39 terminal monitor
Command: terminal monitor
terminal no monitor
Function: Copy debugging messages to current display terminal; the "terminal no
monitor" command restores to the default value
Command mode: Admin mode
Usage guide: Configures whether the current debugging messages is displayed on this
terminal. If this command is configured on telnet or ssh clients, debug messages will be
sent to that client. The debug message is displayed on console by default
Example: Switch#terminal monitor
2.1.1.40 traceroute
Command: traceroute [source <ipv4-addr>]{<ip-addr> | host <hostname> }[hops
<hops>] [timeout <timeout> ]
Function: This command is tests the gateway passed in the route of a packet from the
source device to the target device. This can be used to test connectivity and locate a
failed sector.
Parameter: <ipv4-addr> is the assigned source host IPv4 address in dot decimal format.
<ip-addr> is the target host IP address in dot decimal format. <hostname> is the
hostname for the remote host. <hops> is the maximum gateway number allowed by
Traceroute command. <timeout> Is the timeout value for test packets in milliseconds,
between 100 -10000.
Default: The default maximum gateway number is 30, timeout in 2000 ms.
Command mode: Admin Mode
Usage Guide: Traceroute is usually used to locate the problem for unreachable network
nodes.
2.1.1.41 traceroute6
Command: traceroute6 [source <addr>] {<ipv6-addr> | host <hostname> }[hops
<hops>] [timeout <timeout> ]
Function: This command is for testing the gateways passed by the data packets from
the source device to the destination device, so to check the accessibility of the network
and further locating the network failure.
Parameter: <addr> is the assigned source host IPv6 address in colonned hex notation.
<ipv6-addr> is the IPv6 address of the destination host,shown in colonned hex notation;
57