Edge-Core ES4624-SFP Basic Management Manual page 401

Usage Guide: Clears the content of current ARP table, but it does not clear the current
static ARP table.
Example：
Switch#clear arp-cache
13.5.3.3 clear arp traffic
Command：clear arp traffic
Function：Clear the statistic information of ARP messages of the switch. For box
switches, this command will only clear statistics of APP messages received and sent from
the current boardcard.
Command mode: Admin Mode
Example:
Switch#clear arp traffic
13.5.3.4 ip proxy-arp
Command: ip proxy-arp
no ip proxy-arp
Function: Enables proxy ARP for VLAN interface; the "no ip proxy-arp" command
disables proxy ARP.
Default: Proxy ARP is disabled by default.
Command mode: Port mode
Usage Guide: When an ARP request is received on the layer 3 interface, requesting an
IP address in the same IP segment of the interface but not the same physical network,
and the proxy ARP interface has been enabled, the interface will reply to the ARP with its
own MAC address and forward the actual packets received. Enabling this function allows
machines to physically be separated but in the same IP segment and communicate via
the proxy ARP interface as if in the same physical network. Proxy ARP will check the
route table to determine whether the destination network is reachable before responding
to the ARP request; ARP request will only be responded if the destination is reachable.
Note: the ARP request matching default route will not use proxy.
Example: Enabling proxy ARP for VLAN 1.
Switch(Config-if-Vlan1)#ip proxy-arp
13.5.3.5 ARP Troubleshooting
If ping from the switch to directly connected network devices fails, the following can be
used to check the possible cause and create a solution.
Check whether the corresponding ARP has been learned by the switch.
If ARP has been learned, then enabled ARP debugging information and view
401