Edge-Core ES4624-SFP Basic Management Manual page 173

（9） Configure broadcast storm control function for the switch
（10） Configure the scan mode of the port
（11） Configure rate-violation control of the port
（12） Configure interval of port-rate-statistics
1. Enter the Ethernet port configuration mode
Command
Port mode
interface ethernet <interface-list>
2. Configure the properties for the Ethernet ports
Command
Port mode
combo-forced-mode { copper-forced
| copper-preferred-auto | sfp-forced |
sfp-preferred-auto }
no combo-forced-mode
shutdown
no shutdown
description <string>
no description
mdi { auto | across | normal }
no mdi
speed-duplex {auto [10 [100 [1000]]
[auto | full | half |]] | force10-half |
force10-full |
force100-full |
[module-type {auto-detected
no-phy-integrated | phy-integrated}]
| {{force1g-half
[nonegotiate [master
force10g-full}
no speed-duplex
[no]negotiation
rate-limit<bandwidth> {input|output}
no rate-limit {input|output}
force100-half |
force100-fx
|
| force1g-full}
| slave]]}|
Explanation
Enters the network port configuration
mode.
Explanation
Sets the combo port mode (combo ports
only);the "no
command restores the default combo
mode for combo ports, i.e, fiber ports first.
Enables/Disables specified ports
Names or cancels the name of specified
ports
Sets the cable type for the specified port
Sets port speed and duplex mode of
100/1000Base-TX or 100Base-FX ports.
The "no" format of this command restores
the default setting, i.e., negotiates speed
and duplex mode automatically.
Enables/Disables
function of 1000Base-T ports.
Sets or cancels the bandwidth used for
incoming/outgoing traffic for specified ports
173
combo-forced-mode"
the auto-negotiation