Advertisement
b. Connect DC power to ECS4100-26TX-ME
1
3
Note:
Before wiring the DC plug or connecting power to the
switch, ensure that power to the feed lines is turned off at
the supply circuit breaker or disconnected from the power
bus.
1
The ECS4100-26TX-ME switch supports the option of
connecting an external 36 to 60 VDC power source to its DC
terminal block.
2
Connect the 36 VDC power feed wire to the DC plug "+" pin.
3
Connect the ground/return wire to the DC plug "-" pin.
5. Verify Switch Operation
1
Verify basic switch operation by checking the system LEDs.
When operating normally, the Power and Diag LEDs should
be on green.
6. Perform Initial Configuration
1
1
Connect a PC to the switch console port using the included
console cable.
2
Configure the PC's serial port: 115200 bps, 8 characters, no
parity, one stop bit, 8 data bits, and no flow control.
3
Log in to the CLI using default settings: Username "admin"
and password "admin. "
Note:
For further information on switch configuration, refer
to the Web Management Guide and CLI Reference Guide.
2
2
3
7. Connect Network Cables
1
1
For RJ-45 ports, connect 100-ohm Category 5, 5e or better
twisted-pair cable.
2
For the SFP/SFP+ slots, first install SFP/SFP+ transceivers and
then connect fiber optic cabling to the transceiver ports. The
following transceivers are supported:
◆
1000BASE-SX (ET4201-SX)
◆
1000BASE-LX (ET4201-LX)
◆
1000BASE-ZX (ET4201-ZX)
◆
1000BASE-LHX (ET4201-LHX)
◆
10GBASE-SR (ET5402-SR)
◆
10GBASE-LR (ET5402-LR)
◆
10GBASE-ER (ET5402-ER)
3
As connections are made, check the port status LEDs to be
sure the links are valid. Press the Mode button to change
from Ethernet to PoE status:
◆
On/Blinking Green — Port has a valid link. Blinking
indicates network activity.
◆
On Amber — Port is supplying PoE power.
– 2 –
Quick Start Guide
2
Advertisement
