Ipv6 Dhcp Snooping Binding Enable; Ipv6 Dhcp Snooping Binding Nd - Edge-Core ES4624-SFP Basic Management Manual

Default Settings: Limit blackhole MAC as 10 by the default port.
Usage Guide: Set the max number of the blackhole MAC to avoid the resource
exhaustion of the switch caused by attacks. If the number of alarm information is bigger
than the setting value, then the earliest blackhole MAC will be recovered forcibly while
the new blackhole MAC take effect.
Example: After the abnormity is detected by DHCPv6 Snooping, set the max number of
blackhole MAC as 100 on each non-trusted port.
switch(config)# ipv6 dhcp snooping action 100

33.3.4 ipv6 dhcp snooping binding enable

Command: ipv6 dhcp snooping binding enable
no ipv6 dhcp snooping binding enable
Function: Enable the DHCPv6 Snooping binding funciton globally. The no command
disables the function.
Parameters: None.
Command Mode: Globe mode
Default Settings: DHCPv6 Snooping binding is disabled by default.
Usage Guide: When enabling the binding function of DHCPv6 Snooping to monitor the
DHCPv6 packets, it allows DHCPv6 Snooping binding to be established. This command
limits the dynamic binding and the static binding. After disable the global DHCPv6
Snooping function, the device stops establishing the binding according to DHCPv6
packets.
Example: Establish DHCPv6 Snooping binding according to DHCPv6 REPLY packets.
switch(config)#ipv6 dhcp snooping binding enable

33.3.5 ipv6 dhcp snooping binding nd

Command: ipv6 dhcp snooping binding nd
no ipv6 dhcp snooping binding nd
Function: Globally enable the function that DHCPv6 Snooping binds ND. The no
command disables the function.
Parameters: None.
Command Mode: Globe mode
Default Settings: Disable the function that DHCPv6 Snooping binds ND.
Usage Guide: After this function is enabled globally, send static ND while setting up
DHCPv6 Snooping binding, and convert the already existent DHCPv6 Snooping binding
into the static ND entry. After disable the global DHCPv6 Snooping function, the static ND
661