Edge-Core ES4624-SFP Basic Management Manual page 191

Default: No IP address is configured by default.
Usage Guide: This command configures the IP address for network management port.
Example: Setting the IP address of the network management interface to
192.168.1.10/24.
Switch(Config-If-Ethernet0)#ip address 192.168.1.10 255.255.255.0
3.2.3.2.4 shutdown
Command: shutdown
no shutdown
Function: Shuts down the network management port; the "no shutdown" command
opens the port.
Command mode: Network management port configuration Mode
Default: Network management port is open by default.
Usage Guide: When network management port is shut down, no data frames are sent in
the port, and the port status displayed when the user typed "show interface" command
is "down".
Example: Enabling the network management interface.
Switch(config)#interface ethernet 0
Switch(Config-If-Ethernet0)#no shutdown
3.2.3.2.5 speed
Command: speed {auto | force10 | force100 | force1G}
Function: Sets port speed.
Parameters: auto for auto-negotiation of speed; force10 for forced 10Mbps; force100
for forced 100Mbps; force1G for forced 1000Mbps.
Command mode: Network management port configuration Mode
Default: Auto-negotiation for speed is set by default.
Usage Guide: According to IEEE 802.3, the auto-negotiation for port speed and duplex
are linked. If the port speed setting is auto-negotiation, the port duplex mode will also be
set to auto-negotiation automatically; if the port speed changes from auto-negotiation to
forced, the port duplex mode will also become forced full/half-duplex.
It is strongly recommended for users to set all port speed and duplex mode to
auto-negotiation, this can minimize protocol-related connection problems. If forced
speed/duplex mode needs to be set, the speed/duplex mode setting of both ends must
be verified to be the same.
Example: Setting the network management port to forced 100Mbps.
Switch(config)#interface ethernet 0
Switch(Config-If-Ethernet0)#speed force100
191