Rcommand Member; Rcommand Commander; Cluster Update Member - Edge-Core ES4624-SFP Basic Management Manual

Hide thumbs Also See for ES4624-SFP:

Table of Contents

30.3.9 rcommand member

Command: rcommand member <mem-id>

Function: In the commander switch, this command is used to remotely manage the

member switches in the cluster.

Parameter: <mem-id> commander the member id allocated by commander to each

member, whose range is 1～128.

Command mode: Admin Mode

Usage Guide：After executing this command, users will remotely login to a member

switch and enter Admin Mode on the latter. Use exit to quit the configuration interface of

the member. Because of the use of internal private IP, telnet authentication will be

omitted on member switches.This command can only be executed on commander

Example: In the commander switch, enter the configuration interface of the member

switch with mem-id 1.

Switch#rcommand member 1

Command: rcommand commander

Function: In the member switch, use this command to configure the commander switch.

Command mode: Admin Mode

Instructions: This command is used to configure the commander switch remotely. Users

have to telnet the commander switch by passing the authentication. The command "exit"

is used to quit the configuration interface of the commander switch. This command can

only be executed on member switches.

Example: In the member switch, enter the configuration interface of the commander

Switch#rcommand commander

Command: cluster update member <member-id> <src-url> <dst-filename> [ascii |

Function: Remotely upgrade member switches from the commander switch

Parameters：member-id：ranging from 1 to 128. Use hyphen "-" or semicolon ";" to

specify more than one member;

src-url：the location of source files to be copied;