Edge-Core ES4624-SFP Basic Management Manual page 396

Function：Enable the URPF function on the port.
Parameters：loose：the loose mode;
strict：the strict mode;
allow-default-route：allow the default route.
Command mode: Port Mode
Default：The URPF function is disabled on the port by default.
Usage Guide：Users should specify the mode: loose or strict.
Example:
Switch(config)#interface ethernet 1/4
Switch(Config-If-Ethernet1/4)#ip urpf enable strict
Switch(Config-If-Ethernet1/4)#interface ethernet 1/5
Switch(Config-If-Ethernet1/5)#ip urpf enable loose
Switch(Config-If-Ethernet1/5) #interface ethernet 1/6
Switch(Config-If-Ethernet1/6)#ip urpf enable loose allow-default-route
Switch(Config-If-Ethernet1/6)#interface ethernet 1/7
Switch(Config-If-Ethernet1/7)#ip urpf enable strict allow-default-route
13.4.3.3 show urpf rule ipv4 num
Command：show urpf rule ipv4 num interface {ethernet IFNAME |IFNAME}
Function：Display the number of IPv4 rules bonded to the port.
Parameters：IFNAME: specify the port name.
Command Mode：Admin and Config Mode
Examples：Display the number of IPv4 rules bonded to the port Ethernet1/4.
Switch#show urpf rule ipv4 num interface ethernet 1/4
13.4.3.4 show urpf rule ipv6 num
Command：show urpf rule ipv6 num interface {ethernet IFNAME |IFNAME}
Function：Display the number of IPv6 rules bonded to the port.
Parameters：IFNAME: specify the port name.
Command Mode：Admin and Config Mode
Example：Display the number of IPv6 rules bonded to the port Ethernet1/4.
Switch#show urpf rule ipv6 num interface ethernet 1/4
13.4.3.5 show urpf rule ipv4
Command：show urpf rule ipv4 interface {ethernet IFNAME |IFNAME}
Function：Display the details of IPv4 rules bonded to the port.
Parameters：IFNAME: specify the port name.
Command Mode：Admin and Config Mode
396