Edge-Core ES4624-SFP Basic Management Manual page 72

Function: Display the contents in the memory.
Command mode: Admin Mode
Usage Guide: This command is used for switch debug purposes. The command will
interactively prompt the user to enter start address of the desired information in the
memory and output word number. The displayed information consists of three parts:
address, Hex view of the information and character view.
Example:
Switch#show memory
start address : 0x2100
number of words[64]:
002100: 0000 0000 0000 0000 0000 0000 0000 0000
002110: 0000 0000 0000 0000 0000 0000 0000 0000
002120: 0000 0000 0000 0000 0000 0000 0000 0000
002130: 0000 0000 0000 0000 0000 0000 0000 0000
002140: 0000 0000 0000 0000 0000 0000 0000 0000
002150: 0000 0000 0000 0000 0000 0000 0000 0000
002160: 0000 0000 0000 0000 0000 0000 0000 0000
002170: 0000 0000 0000 0000 0000 0000 0000 0000
2.2.7.1.7 show memory usage
Command: show memory usage [<slotno>]
Function: Show memory usage rate.
Command mode: Admin and configuration mode.
Usage Guide: Check the current usage of memory resource by show memory usage
command. Only the chassis switch uses slotno parameter which is used to show the
memory usage rate of card on the specified slot, if there is no parameter, the default is
current card.
Example: Show the current usage rate of the memory.
Switch#show memory usage
The memory total 128 MB, free 58914872 bytes, usage is 56.10%
2.2.7.1.8 show running-config
Command: show running-config
Function: Display the current active configuration parameters for the switch.
Default: If the active configuration parameters are the same as the default operating
parameters, nothing will be displayed.
Command mode: Admin Mode
Usage Guide: When the user finishes a set of configuration and needs to verify the
configuration, show running-config command can be used to display the current active
*................*
*................*
*................*
*................*
*................*
*................*
*................*
*................*
72