Ipv6 Nd Snooping User-Control; Show Ipv6 Nd Snooping Binding - Edge-Core ES4624-SFP Basic Management Manual

Command mode: Port Mode.
Default: un-trusted port.
Usage Guide: This command sets a port or a group of ports as the trust port and deletes
all dynamic binding corresponding with the port or ports, stop creating new binding of port
or ports, and accessing of packets is also allowed.
Example: Set a port or a group of ports as the trust ports.
Switch(config)#interface ethernet 1/1
Swithc(config-if-ethernet1/1)# ipv6 nd snooping trust

34.3.12 ipv6 nd snooping user-control

Command: ipv6 nd snooping user-control
no ipv6 nd snooping user-control
Function: Enable the control function of the ports for ND Snooping.
Parameter: None.
Command mode: Port Mode.
Default: Disable the control function of ND Snooping.
Usage Guide: After the control function of ND Snooping is disabled, clear all FFP drive
entries which are sent by ND Snooping for this port, but the binding information is not
deleted.
Example: Configure ND Snooping function on the port.
Switch(config)#ipv6 nd snooping enable
Switch(config)#interface ethernet 1/1
Swithc(config-if-ethernet1/1)# ipv6 nd snooping user-control

34.3.13 show ipv6 nd snooping binding

Command: show ipv6 nd snooping binding [<ipv6-address> | <hardware-address>
| <interface-name> | <all>]
Function: Show the global configuration and all binding information of ND Snooping, or
the configuration and the binding information of a port.
Parameter: ipv6-address: Show the binding information according to the specified IPv6
address.
hardware-address: Show the binding information according to the specified
MAC address.
interface-name: Show the binding information according to the specified port.
all: Show all information.
Default: None.
679