Edge-Core ES4624-SFP Basic Management Manual page 63

2.2.3.3 Commands for Telnet
2.2.3.3.1 telnet
Command: telnet [vrf <vrf-name>] {<ip-addr> | <ipv6-addr> | host <hostname>}
[<port>]
Function: Log on the remote host by Telnet
Parameter：<vrf-name> is the specific VRF name; <ip-addr> is the IP address of the
remote host,shown in dotted decimal notation; <ipv6-addr> is the IPv6 address of the
remote host; <hostname> is the name of the remote host, containing max 64 characters;
<port> is the port number,ranging between 0~65535.
Command Mode: Admin Mode
Usage Guide: This command is used when the switch is applied as Telnet client, for
logging on remote host to configure. When a switch is applied as a Telnet client, it can
only establish one TCP connection with the remote host. To connect to another remote
host, the current TCP connection must be disconnected with a hotkey "CTRL+ \". To
telnet a host name, mapping relationship between the host name and the IP/IPv6
address should be previously configured. For required commands please refer to ip host
and ipv6 host. In case a host corresponds to both an IPv4 and an IPv6 addresses, the
IPv6 should be preferred when telneting this host name.
Example:
1) The switch Telnets to a remote host whose IP address is 20.1.1.1
Switch#telnet 20.1.1.1 23
2) The switch Telnets to a remote host whose IPv6 address is 3ffe:506:1:2::3
Switch#telnet 3ffe:506:1:2::3
3) Configure the mapping relationship between the host name ipv6host and the IPv6
address 3ffe:506:1:2::3, and then telnet to host ipv6host
Switch#config
Switch(config)# ipv6 host ipv6host 3ffe:506:1:2::3
Switch#telnet host ipv6host
2.2.3.3.2 ip telnet server
Command: ip telnet server
no ip telnet server
Function: Enable the Telnet server function in the switch: the "no ip ip telnet server"
command disables the Telnet function in the switch.
Default: Telnet server function is enabled by default.
Command mode: Global Mode
Usage Guide: This command is available in Console only. The administrator can use this
63