Edge-Core ES4624-SFP Basic Management Manual page 54

Displayed Information
ping6
Target IPv6 address
Output Interface
Use source IPv6 address [n]:
Source IPv6 address
Repeat count[5]
Datagram size in byte[56]
Timeout in milli-seconds[2000]
Extended commands[n]
!
.
Success rate is 100 percent (8/8),
round-trip min/avg/max = 1/1/1 ms
2.1.1.31 reload
Command: reload
Function: Warm reset the switch.
Command mode: Admin Mode
Usage Guide: The user can use this command to restart the switch without power off.
2.1.1.32 service password-encryption
Command: service password-encryption
no service password-encryption
Function: Encrypt system password. The "no service password-encryption" command
cancels the encryption
Command mode: Global Mode
Default: no service password-encryption by system default
Usage guide: The current unencrypted passwords as well as the coming passwords
configured by password, enable password, ip ftp and username command will be
encrypted by executed this command. no service password-encryption cancels this
Explanation
Run ping6 function
Destination IPv6 address
Name of Vlan interface,required to be
specified when destination address is a
link-local address
Use source IPv6 address, not used by
default
Source IPv6 IP address
Number of ping packets to be sent,5 by
default
Size of Ping packet,56 by default
Permitted delay time, 2 seconds by default
Configuration of extended parameter, not
applied by default
Indicate the network is accessible
Indicate the network is inaccessible
Statistic information,indicating that ping
packets has succeeded in arriving in 100%
without any packet lost
54