Edge-Core ES4624-SFP Basic Management Manual page 311

Switch(config)#interface ethernet 1/1
Switch(Config-If-Ethernet1/1)#port security
10.6.1.3.4 port-security lock
Command: port security lock
no port-security lock
Function: Lock the port, when a port is locked, the MAC address learning function will be
disabled ; the "no port-security" command restores the MAC address learning function
for the port.
Command mode: Port Mode.
Default: Port security lock is not enabled by default.
Usage Guide: When config the command, you must make sure that there is dynamic
mac on the interface,if there is no dynamic mac on the interface, the interface will down.
Example: Lock the port 1.
Switch(config)#interface ethernet 1/1
Switch(Config-If-Ethernet1/1)#port-security lock
10.6.1.3.5 port-security convert
Command: port-security convert
Function: Converts dynamic secure MAC addresses learned by the port to static secure
MAC addresses, and disables the MAC address learning function for the port.
Command mode: Port mode.
Usage Guide: The port dynamic MAC convert command can only be executed after the
secure port is locked. After this command has been executed, dynamic secure MAC
addresses learned by the port will be converted to static secure MAC addresses. The
command does not reserve configuration.
Example: Converting MAC addresses in port 1 to static secure MAC addresses.
Switch(config)#interface Ethernet 1/1
Switch(Config-If-Ethernet1/1)# port-security convert
10.6.1.3.6 port-security mac-address
Command: port-security mac-address <mac-address>
no port-security mac-address <mac-address>
Function: Adds a static secure MAC address; the "no port-security mac-address"
command deletes a static secure MAC address.
Command mode: Port mode.
Parameters: <mac-address> stands for the MAC address to be added/deleted.
Usage Guide: The MAC address binding function must be enabled before static secure
311