Edge-Core ES4624-SFP Basic Management Manual page 257

9.1.3.1 vlan
Command: vlan <vlan-id>[name <vlan-name>]
no vlan <vlan-id>[name]
Function: Create VLANs and enter VLAN configuration mode, and can set VLAN name.
In VLAN Mode, the user can assign the switch ports to the VLAN. The "no vlan
<vlan-id>" command deletes specified VLANs.
Parameter: <vlan-id> is the VLAN ID to be created/deleted, valid range is 1 to 4094,
connect with";" and "-".
<vlan-name> is the name that creates VLAN, valid range is 1 to 16 characters.
Command mode: Global Mode.
Default: Only VLAN1 is set by default.
Usage Guide: VLAN1 is the default VLAN and cannot be configured or deleted by the
user. The maximal VLAN number is 4094. It should be noted that dynamic VLANs learnt
by GVRP cannot be deleted by this command.
Example: Create VLAN100-200 and enter the configuration mode for VLAN 100.
Switch(config)#vlan 100-200
Switch(config)#vlan 100
Switch(Config-Vlan100)#
9.1.3.2 vlan internal
Command: vlan <2-4094> internal
Function: Specify the internal VLAN ID. After an ID is specified as the internal VLAN ID,
it is not allowed to be used by other VLAN. Internal VLAN is only used to LOOPBACK
interface and can not add physical port. New internal VLAN ID takes effect after save the
configuration and reboot the switch.
Parameter: <vlan-id>: The ID is specified as internal VLAN ID, the range is 2 to 4094.
Command mode: Global Mode.
Default: 1006.
Usage Guide: Set 1006 as the default internal VLAN ID, the internal VLAN ID needs to
be modified when the network set 1006 as VLAN ID. Internal VLAN ID must select an
unused ID or else affect other VLAN. This command takes effect after save the
configuration and reboot the switch.
Example: Set 100 as the internal VLAN ID.
Switch(config)#vlan 100 internal
9.1.3.3 private-vlan
257