Edge-Core ES4624-SFP Basic Management Manual page 152

would be available. RADIUS Server will be searched by the configured order if primary is
not configured, otherwise, the specified RADIUS server will be used last.
[access-mode {dot1x|telnet}] designates the current RADIUS server only
use 802.1x authentication or telnet authentication, all services can use current RADIUS
server by default.
Command mode: Global Mode
Default: No RADIUS authentication server is configured by default.
Usage Guide: This command is used to specify the IPv4/IPv6 address and port number,
cipher key string and access mode of the specified RADIUS server for switch
authentication, multiple command instances can be configured. The port parameter is
used to specify authentication port number, which must be the same as the specified
authentication port in the RADIUS server, the default port number is 1812. If this port
number is set to 0, the specified server is regard as non-authenticating. This command
can be used repeatedly to configure multiple RADIUS servers communicating with the
switch, the configured order is used as the priority for the switch authentication server.
When the first server has responded (whether the authentication is successed or failed),
switch does not send the authentication request to the next. If primary is specified, then
the specified RADIUS server will be the primary server. It will use the cipher key which be
configured by radius-server key <string> global command if the current RADIUS server
not configure key<string>. Besides, it can designate the current RADIUS server only use
802.1x authentication or telnet authentication via access-mode option. It is not configure
access-mode option and all services can use current RADIUS server by default.
Example: Setting the RADIUS authentication server address as 200.1.1.1.
Switch(config)#radius-server authentication host 200.1.1.1
2.11.3.13 radius-server dead-time
Command:radius-server dead-time <minutes>
no radius-server dead-time
Function:Configures the restore time when RADIUS server is down; the "no
radius-server dead-time" command restores the default setting.
Parameters:<minute > is the down -restore time for RADIUS server in minutes, the valid
range is 1 to 255.
Command mode: Global Mode
Default: The default value is 5 minutes.
Usage Guide: This command specifies the time to wait for the RADIUS server to recover
from inaccessible to accessible. When the switch acknowledges a server to be
inaccessible, it marks that server as having invalid status, after the interval specified by
this command; the system resets the status for that server to valid.
152