Clear Lldp Remote-Table; Lldp Function Typical Example - Edge-Core ES4624-SFP Basic Management Manual

sending of packets and other information on the port.
Example：Enable the debug switch of LLDP function on the switch.
Switch(config)#debug lldp packets interface ethernet 1/1
%Jan 01 00:02:40 2006 LLDP-PDU-TX

7.3.19 clear lldp remote-table

Command：clear lldp remote-table
Function：Clear the Remote-table on the port.
Parameters：None.
Default：Do not clear the entries.
Command Mode：Port configuration mode.
Usage Guide：Clear the Remote table entries on this port.
Example：
Switch(Config-If-Ethernet 1/1)#clear lldp remote-table

7.4 LLDP Function Typical Example

Fig 7-1 LLDP Function Typical Configuration Example
In the network topology graph above, the port 1,3 of SWITCH B are connected to
port 2,4 of SWITCH A. Port 1 of SWITCH B is configured to message-receiving-only
mode, Option TLV of port 4 of SWITCH A is configured as portDes and SysCap.
SWITCH A configuration task sequence:
SwitchA(config)#lldp enable
SwitchA(config)#interface ethernet 1/1
SwitchA(Config-If-Ethernet1/1)#lldp mode receive
SwitchA(Config-If-Ethernet1/1 )#exit
PORT= ethernet 1/1
236