Installing The Tape Blade; Installation Order - NEC Express5800 Series User Manual

INSTALLING THE TAPE BLADE

Install the Tape Blade in the dedicated Blade Enclosure. The slot to install the Tape Blade must be
the one adjacent to the CPU blade to which the Tape Blade is to be connected. See "Installation
Order" described later in this chapter for how to install the Tape Blade in the slot.
Refer to the User's Guide of Blade Enclosure for how to install the Blade Enclosure.
IMPORTANT:
electricity. Make sure to touch the metal frame of the Tape Blade to
discharge static electricity from your body before handling the Tape
Blade. Do not touch the pins, leads, or circuitry and place the Tape
Blade directly on the desk. For static notes, see "Anti-static Measures"
in Chapter 9.

Installation Order

Install the Tape Blade into the slot adjacent to the target CPU blade.
See the description below for installation order.
SIGMABLADE-H
A pair of a CPU blade and a Tape Blade occupies two slots as shown below.
Slots 1 and 2, slots 3 and 4, slots 5 and 6, or slots 7 and 8
Slots 9 and 10, slots 11 and 12, slots 13 and 14, or slots 15 and 16
Slot Slot
1
Slot Slot
9
NOTE:
composing a pair.
The Tape Blade is extremely sensitive to static
Slot Slot Slot
2 3 4 5
Slot Slot Slot
10 11 12 13
A Tape Blade may be installed in either of the two slots
Slot Slot Slot
6 7 8
Slot Slot Slot
14 15 16
Setting Up Your Tape Blade
3-3